Products
Rolling mill equipment, in line order.
Each chapter is a station in the line: what it does, how it works, what we build, and what to send us.
Schematic, not to scale. Numbers: product chapters.← Swipe to see the whole drawing →
- 01 Reheating furnace & furnace area mechanical equipment
- 02 Industrial furnaces
- 03 Rolling mill stands
- 04 Rolling mill shears
- 05 Rolling mill guides
- 06 Gearboxes
- 07 Pinch rolls
- 08 Cooling systems
- 09 Wire rod mill equipment
- 10 Cooling beds
- 11 Straightening machines
- 12 Meltshop mechanical equipment
01 Reheating furnace & furnace area mechanical equipmentBefore the first pass, every billet must arrive at the right temperature, in the right place, at the right moment.
02 Industrial furnacesNot every furnace stands in front of a rolling mill.
03 Rolling mill standsTolerances are won or lost in the stand.
04 Rolling mill shearsMost cuts in a rolling mill are made on steel in motion.
05 Rolling mill guidesA bar that enters the groove off-centre becomes a cobble.
06 GearboxesIn most mills, every kilowatt that reaches the rolls passes through a gearbox.
07 Pinch rollsWherever the bar must be pushed, braked or steered, a pinch roll takes hold of it.
08 Cooling systemsAfter the finishing stand, controlled water cooling decides the final microstructure.
09 Wire rod mill equipmentAt the end of a rod mill the product leaves the last stand at up to 100 m/s: 360 km/h.
10 Cooling bedsThe cooling bed is where speed turns into straightness.
11 Straightening machinesStraight bars, square ends, the right count, a tight binding: the finishing shop is the mill's handshake with the customer.
12 Meltshop mechanical equipmentMeltshop equipment works beside liquid steel, under radiant heat, dust and shock loads.
02 Industrial furnacesNot every furnace stands in front of a rolling mill.
03 Rolling mill standsTolerances are won or lost in the stand.
04 Rolling mill shearsMost cuts in a rolling mill are made on steel in motion.
05 Rolling mill guidesA bar that enters the groove off-centre becomes a cobble.Contact
Start with a drawing.
Or a worn part, a pass schedule, an output target. Tell us what the line needs, and an engineer will answer.
